Whole House Reverse Osmosis

Posted on May 13th, 2009 by admin

Filed under Reverse osmosis systems | 1 Comment »

How Does Whole House Reverse Osmosis Work? This video shows it live and in action from beginning to end. The water softener and water filters act as pretreatment for the System. A water holding tank and delivery pump are the final stages

Duration : 0:1:3

Read the rest of this entry »

Technorati Tags: , , ,

How to test Reverse Osmosis system?

Posted on May 10th, 2009 by admin

Filed under Reverse osmosis systems | 1 Comment »

I acquired a small sink-side reverse osmosis device used. It seems to work, producing a trickle versus a heavier stream out the waste. But how do I know the membrane is intact? How do I know the process is working? Can anyone think of a simple test?

1.) I think you should use regular osmosis to test the membrane. If that works, then you assume that the membrane is fine.
2.) Do the reverse osmosis process and test the water. I would use a boiling test. If the boiling point is higher, then you have solute within the water and the process did not work.

Some equations to predict if you have what you want:
pi=iMRT (van't hoff equation)
delta (temp) = iKbm (boiling point equ. m=molality, Kb=constant of water, i=ions)
good luck.

Part 1 Theory of Reverse Osmosis units and how to optimize p

Posted on May 8th, 2009 by admin

Filed under Reverse osmosis systems | 9 Comments »

This is part 1 of a 2 part series on how you can configure a working whole-house RO system.

Duration : 0:9:55

Read the rest of this entry »

Technorati Tags: , , , , , , , , ,

How to fill an air tank with a reverse osmosis system?

Posted on May 7th, 2009 by admin

Filed under Reverse osmosis systems | 2 Comments »

I have a 4 gallon tank which is supposed to have 7 lbs. with the tank empty. I need to know the precise procedure to follow. Thank you in advance.

Assuming you're talking about the pressure tank, which consists of an air chamber and a diaphram to hold pressure against the water, you should have a psi guage installed in the tank and an inlet (similar to a tire valve). Then, add 7 P.S.I. with a hand pump, foot pump or compressor. CAUTION: if you use a compressor that handles tire inflation, tools etc., be very quick! and prepared to release some air.

How To Re-Pressurize Your Reverse Osmosis Holding Tank

Posted on May 6th, 2009 by admin

Filed under Reverse osmosis systems | No Comments »

The number one reason for low water flow from a reverse osmosis system is due to the holding tank losing its air pressure. This video describes how to service your RO holding tank and re-pressurize the tank to the proper air pressure.

Duration : 0:6:19

Read the rest of this entry »

Technorati Tags: , , , , , , , ,

Hydranautics: Spiral Wound Reverse Osmosis Elements

Posted on May 3rd, 2009 by admin

Filed under Reverse osmosis systems | No Comments »

Hydranautics manufactures reverse osmosis (RO), nanofiltration (NF), ultrafiltration (UF) membrane products and microfiltration (MF) for water treatment applications around the world, helping meet increasingly stringent regulations and ensure the highest water quality. For more information about Hydranautics membrane products please call 1-800-CPA-PURE or 760-901-2500, visit us online at www.membranes.com or send an e-mail to info@hydranautics.com

Duration : 0:3:20

Read the rest of this entry »

Technorati Tags: , , , , , , ,

Does a reverse osmosis system have to produce waste water in order to be effective?

Posted on May 3rd, 2009 by admin

Filed under Reverse osmosis systems | 2 Comments »

Or can it purify water without producing any waste water and if so where do the impurities go?

Reverse osmosis does not have to produce waste water at all, but in that case the filtering system gets clogged in minutes. So, the waste water is produced not in process of reverse osmosis, but in processes of cleaning the filters. All the impurities are held in filter system, until washing, when they go to the washing water, which gets polluted.

Reverse Osmosis 2A, Subpart b - Whole House Adaptation

Posted on May 1st, 2009 by admin

Filed under Reverse osmosis systems | 2 Comments »

This is the second part (made itself of 2 parts subpart a and b) on reverse osmosis. The fist part in the series covers theory and the system components that are actually shown in part 2. They are shown but not discussed in detail. The system isnt very professional in appearance mainly because it started out as a simple concept of building a CPVC dedicated piping system into the house as it was being built to serve each vanity in the house, the kitchen sink and refrigerator. The concept was to be driven by a conventional 3-stage under-sink RO system with a much larger storage tank. The only additional original modification was to add a large whole-house carbon filter for additional finishing. The system worked but at lower than satisfactory volumes therefor a low-volume/high-pressure diaphragm pump was added. This improved production but ice cubes were still smaller and tea jugs and coffee pots took longer to fill than we liked so a permeate pump was added. Finally, after a number of years the under-sink 3-stage unit failed and was replaced with a simple 75 GPD membrane and housing.

Duration : 0:9:29

Read the rest of this entry »

Technorati Tags: , , , , , , , , ,

I am looking at Reverse Osmosis Water filtration systems. Can you recommend a brand? Why or why not?

Posted on April 30th, 2009 by admin

Filed under Reverse osmosis systems | 4 Comments »

Watts looks good if you live near a sales rep and are filty rich - I am not.

espring thinks flouride is good for you, which it's not.

home depot sells GE 10gpd for under 250 bucks. this is comparable to the systems i used to sell for 1200 ! if you cant install it about 50 dollars is what a handyman should charge. RO delivers the best quality water in your home for drinking and cooking, anything that goes in your body. my motto, if it is not there it cant hurt you!

Reverse Osmosis 2A, Subpart a - Whole House Adaptation

Posted on April 26th, 2009 by admin

Filed under Reverse osmosis systems | 2 Comments »

This is the second part (made itself of 2 parts subpart a and b) on reverse osmosis. The fist part in the series covers theory and the

Duration : 0:10:0

Read the rest of this entry »

Technorati Tags: , , , , , , , , ,